Home > Home Improvement > Top 7 Tips For Maintaining Wood Fireplace

Top 7 Tips For Maintaining Wood Fireplace

Wood fireplace repair can help you in keeping your fireplace clean and maintained. Now who doesn’t love properly maintained wood fireplace? Following are some of the tips you can follow to keep your fireplace retained:

Tips for Maintaining Wood Fireplace

You must have noticed that during a wood stove insert, the experts first assemble the place properly removing any old debris or cracked up surfaces which results in giving you a beautiful fireplace. Similarly work through with your house and make sure to have a wood fireplace repair, so come winter your fireplace will be sleek, beautiful and ready to sprout out some heat!

  1. Clean The Debris

Usually during a wood stove insert, you’ll notice a layer of debris surrounding the place. Same goes for your fireplace, clean any extra layered debris surrounding it. The debris can block out your fire or will enable harmful smoke to emit through your fireplace hence clean out any debris or other rubbish like soot surrounding it.

  1. Creosote

During wood fireplace repair, you must have noticed that experts look for creosote. Creosote is tar like substance formed by unburned gases from wood fires. Creosote requires thorough cleaning hence once you properly remove it, then your fire will be pollution free and your fireplace clean of unwanted rubbish.

  1. Use Hard Wood

While putting up a fire, make sure you use only hard woods like maple, oak etc. as these woods will not cause much smoke or harm to you and your house. Using other soft woods can cause abundant smoke to pile up increasing the chances of creosote and soot which will require you to opt wood fireplace repairs again.

  1. Stainless Steel

It is better to cover your chimney insides with stainless steel or steel sheets. It will make it easy for you to clean and keep your fireplace clean. Also, this prevents from soot or blackness appearing on the inside of your chimneys.

  1. Damp Wood

Avoid using damp wood because damp wood takes a lot of time to burn and in the process of doing so, it can damage your fireplace completely. So whenever you want to use your fireplace, check the wood for dampness, if it is damp then dry it out completely or discard it and get new dry wood for your fire.

  1. Check The Cover

If your chimney is also covered on the top, then make sure the cover is completely clean to avoid the accumulation of smoke. Covers are usually put to avoid rain, leaves or critters from entering the chimney hence when planning on using the fireplace, make sure to check your covers!

  1. Fire Cover

Fire cover is an essential step to take if you contain a wooden fireplace. The cover should be present in front of the fire and below the steel covering on top of the chimney. It is usually a net type covering. This net type covering prevents harmful ash or coal or piece of burning wood to burn your carpet or floor and help in the removal of smoke on top of chimneys.

Final Verdict

Hence just like in the wood stove insert, where you have to check all the necessary details before going for it, similarly do the same with your fireplace before you start using it. The result will be a properly maintained, and danger free fireplace! Hire a chimney fireplace sweep marlboro md.

You may also like
All that you need to know about chimney inspection

Leave a Reply